|
BACK
NEXT
2.1.4. Running LED
( Get the idea by your self )
Do it, same lesson as 2.a.3 by changing the instruction mov P0,#xxxxxxxxb
with Setb P0.x or Clr P0.x
2.1.5. Running LED
( Get the idea by your self )
Save your space of assembly program by using RR or RL instruction, see
Lesson1 for complete set instruction.
2.1.6. Running LED ( Get the
idea by your self )
Try another set instruction assembly
to run your LED right and left by using RRC and RLC, feel the diference.
2.2.
SWICHT
2.2.1. Turn on LED when you're push the button
A simple way, how to demonstrate input data
is by using swicht push button, of course this swicht is mechanically
operated. When you are pushing the swicht then the port will get a low
logic and high logic in vice reversa.
Step 1st
Build the circuit as shown in figure 2.2.1. As you seen on figure 2.2.1.
P2.0 trough P2.7 is connected to swicht push button each and LED's Katode
is connected to P0.0 trough P0.7. Remember, that all we want to do with
this lesson is make a LED on when, the button connected to P2.0 or P2.1.
pushed
Figure 2.2.1. Diagram Skematik Input Data
Step
2nd
In this step, you must tipe the assembly program to make your LED on
when you push the swicht, we assume that you have already known the
editor, we used MIDE-51 to edit the program.
org 0h
start: mov A,P2 ; get the data from swicht and save to Acc.
mov P0,A ; send the data in Acc to P0
sjmp start
end
Step
3rd
Safe your assembly program above, and name it with SW1.asm (for example)
Compile the program that you have been save by using MIDE-51, see the
software instruction.
Step 4th
Download your hex file ( SW1.hex ) into the microcontroller
by using Microcontroller ATMEL ISP software, see the instruction.After
download this hex file you'll see the action of the LED ( of course
if your cable connection and your program are corrected ).
BACK
NEXT
|
